Common Section; Transmitter Section: Adjustment Mode Setting Items - Kenwood TM-D710A Service Manual

Common Section

Item Condition
1.Setting 1) Power supply voltage
DC power supply terminal
: 13.8V
2. Full reset 1) Full reset
Turn the transceiver power ON by pressing the power switch while [F] key is pressed. Release the [F] key.
Select reset type "FULL RESET" by tunring the Tuning control when the reset confi rmation message appears.
Press the Tuning control to set the reset type.
Press the Tuning control again to perform the full reset.
∗ This adjustment mode has an adjustment item to be used as is in the user mode setting contents (AIP, menu mode, etc).
Therefore, if you do not perform the full reset, it may be adjusted unintentionally.
Note:
When you do not want to remove data such as memory channel data, save the data using the MCP-2A (Memory control
program) before performing the full reset, then write the data to the transceiver after performing the adjustment.

Transmitter Section: Adjustment Mode Setting Items

(Refer to the table on pages 36 to 38 for the frequencies which will apply in the adjustment mode.)
Item Condition
1. Frequency 1) Adj item: [FRQ A]
(Band A) Adjust: [
***
Adjust 2) PTT: ON
2. Frequency 1) Adj item: [FRQ B]
(Band B) Adjust: [
***
Adjust 2) PTT: ON
3. High power 1) Adj item: [HPWR V]
Adjust Adjust: [
***
• 144MHz band 2) PTT: ON
• 430MHz band 3) Adj item: [HPWR U]
Adjust: [
***
4) PTT: ON
4. Mid power 1) Adj item: [MPWR V]
Adjust Adjust: [
***
• 144MHz band 2) PTT: ON
• 430MHz band 3) Adj item: [MPWR U]
Adjust: [
***
4) PTT: ON
5. Low power 1) Adj item: [LPWR V]
Adjust Adjust: [
***
• 144MHz band 2) PTT: ON
• 430MHz band 3) Adj item: [LPWR U]
Adjust: [
***
4) PTT: ON
ADJUSTMENT
Measurement
Test-
Unit
equipment
Measurement
Test-
Unit
equipment
f. counter TX/RX
] unit
(Rear)
]
Power meter
]
]
]
]
]
]
TM-D710A/D710E
Adjustment
Terminal Unit Parts
Adjustment
Terminal Unit Parts
ANT Operation Tuning Write
panel control
(Front)
Write
Write
Write
Specifi cations / Remarks
Method
Specifi cations / Remarks
Method
435.100MHz±100Hz E,M4
444.100MHz±100Hz K
50W±1W
48W±1W
12W±1W K,E
22.5W±1W M4
5W±1W
39