Maintenance Instructions - Prosharp AS 2001-Allpro Original Instructions Manual

FINLAND
T. +358 40 5309 392
E. raimo@prosharp.net
Change of the grinding wheel and all service work may only be done when the main power is switched off.
Before every grinding:
After grinding:
After 1-10 pairs:
After 200-400 pairs:
After 800-1000 pairs:
After 2000-3000 pairs:

Maintenance Instructions

Please check that:
1. You have read and understood the safety
instructions and all functions.
2. The grinding wheel is OK, dust-cleaner is
connected and that the motor is running without
vibrations.
Lock the machine and take the key away. Clean
the machine from dust with the dust-cleaner and
use a dry rag to clean up.
Never use oil or grease. Light fleeting liquid is
OK.
Dress the grinding wheel.
Time to change grinding-wheel (page 9). The
number of pairs/wheel depends on how often you
dress the wheel, type of steel etc. For best
grinding result, use only special-balanced
ProSharp grinding wheels.
Check the dressing-tool. The diamond must be
pointed and even for best grinding result. Use
only special-centered dressing-tool, NDT1 or
NDT3, for exact dressing and best grinding-result.
The driving-belt should be perfectly stretched,
Loosen the belt-shroud (2 bolts).
Check the driving-belt by starting the motor. The
belt must run even and smooth.
In cause of belt-tension:
Take off the driving belt.
Loosen bolts by motor-shaft (2 M8). Move the
motor 2-3 mm to the right. Put the 2 M8 back.
Put the driving belt back.
Test run.
Put the belt-shroud back.
The wire that transports the skate shall be
stretched.
Tip the machine forward, check wire on the back.
Check tension of the wire.
In cause of wire-tension:
Loosen nut in center.
Lift off screw and unscrew key nut (one side).
Turn the "body" of the screw 2-3 rounds, or until
the wire feels tightened. Lock the key nut (one
side).
Put the screw back,' and lock the nut.
page 8