Monogramming And Embroidering With Embroidery Hoop; Applique - Silvercrest SNM 33 A1 Instruction Manual

Silver Crest SNM 33 A1

Monogramming and embroidering with embroidery hoop

* Embroidery hoop not included with machine.
Stitch
Attach the darning plate
- Remove the presser foot and the presser
foot holder.
- Attach the darning plate.
- Lower presser foot lever before starting to
sew.
- Adjust the stitch width according to the size
of lettering or design.
Preparation for Monogramming and
Embroidering*
- Draw the desired lettering or design on the
right side of the fabric.
- Stretch the fabric between embroidery hoop
as firmly as possible.
- Place the fabric under the needle. Make
sure the presser foot bar is down in its
lowest position.
- Turn the balance wheel towards you to
bring up the lower thread through the fabric.
Sew a few securing stitches at the starting
point.
- Hold the hoop with thumb and forefingers of
both hands.
- Coordinate sewing speed and movement of
hoop.

Applique

Stitch
- Cut out the applique design and baste it to
the fabric.
- Sew slowly around the edge of the design.
- Trim excess material outside the stitching.
Make sure not to cut any stitches.
- Remove the basting thread.
- Tie top and bottom thread under the
applique to avoid unraveling.
17
Stitch width Stitch length
B 1~5
Stitch width Stitch length
B 3~5
0
0.5~1