Blind Hem Foot - Silvercrest SNM 33 A1 Instruction Manual

Silver Crest SNM 33 A1
1
2

Blind hem foot

4
3
Button sewing foot
13
Stitch Stitch width Stitch length
D
For hems, curtains, trousers, skirts, etc.
Blind hem/ lingerie for firm fabrics.
Fold the fabric as illustrated with the wrong
side uppermost. (1)
Place the fabric under the foot. Turn the
handwheel forwards by hand until the needle
swings fully to the left. It should just pierce the
fold of the fabric. If it does not, adjust the stitch
width accordingly. (2)
Adjust the guide (3) by turning the knob (4)
so that the guide just rests against the fold.
Sew slowly, by pressing the foot control
lightly guiding the fabric along the edge of the
guide.
Stitch Stitch width Stitch length
B
Install the darning plate. This will cover the
feeddog and the stitch length will be disabled
Position the work under the foot. Place the
button on the marked position, lower the foot,
adjust stitch width to "0" and sew a few
securing stitches. Adjust the stitch width
according to the button
to check that the needle goes cleanly into the
left or right hole of the button, and sew on the
button. Adjust the stitch width to "0" and sew
a few securing stitches.
If a shank is required, place a darning needle
on top of the button and sew. For buttons
with 4 holes, sew through the front two holes
first, push work forward and then sew
through the back two holes as described.
1~2 3~5
0~5 0
. Turn the handwheel
.