Uses; Assembly; Check Before Operating - Husqvarna FS 6500 Operator's Manual

• Mandatory
• Obligatorio
• Indication
• Indicación
These signs will give advice for your safety
Before leaving our factory every machine is
thoroughly tested.
Follow our instructions strictly and your
machine will give you long service in normal
operating conditions.
1. Features
Use: Wet sawing of old and new concrete
and asphalt.
Tools: Diamond blades — water cooled, Ø:
12",14", 18", 20", 24", 26", 30", 36" with
Arbor Ø - 1".
(For information contact your Dealer)
Depth of Cut (Maximum):
Maximum Cutting Depth
Blade
12"
Diameter
Maximum
3.5" 4.5"
Cutting
Depth
Maximum Cutting Depth
Blade
26"
Diameter
Maximum
10.5"
Cutting
Depth
Maximum material Size: N/A
Nominal & Operating Weight: See
"Specifications".
Dimensions & Shaft RPM: See "Saw
Dimensions".
Before starting up machine make sure
you read these instructions and are
familiar with the operation of this
.
machine
• Prohibition
• Prohibición
• Warning Triangle
• Triángwulo De
Advertencia
14" 18" 20" 24"
6.5" 7.5" 9.5"
30" 36" --
12" 15" --
The working area must be completely clear,
well lit and all safety hazards removed (no
water or dangerous objects in the vicinity)
Any persons not involved in the work,
should leave the area.
Only work of flat horizontal areas.
Working on steep slopes or hills could
cause the operator to lose control of the
machine. This could result in injury or
death to the operator or other persons in
or near the work area!
Use only blades marked with a
maximum operating speed greater
than the blade shaft speed.

2. Assembly

When unpacked, this unit is fully
assembled, except for installation of the
Muffler. For tool installation see Section 4
of this document.

3. Check Before Operating

All Models:
--
--
Take into account the working conditions from
a health and safety point of view.
For start up refer to the engine, or motor
manual.
Engine Fuel: Check the engine operation
manual. Unleaded gasoline is recommended.
Engine Oil: When the engine is in a horizontal
position, check that the engine oil level is
14
The operator must wear
protective clothing
appropriate to the work he
is doing.
We recommend hearing,
respiratory and eye
protection.