Frigidaire Gas & Electric Dryer Installation Instructions Manual page 8

"Window Door" Reversal Instructions:
1. Open the dryer door. Remove the four hinge hole plugs
from the left side of the door opening. Place nearby for
future installation. NOTE: You may need a plastic knife
to help pull out the plugs. Be careful not to scratch the
paint.
2. Remove the four screws that secure the door hinges to
the dryer front panel. NOTE: Remove one screw from
each of the two hinges first. Hold the door firmly before
removing the last two screws.
3. Remove door handle hole plugs. NOTE: You may need a
plastic knife to help pull out the plugs. Be careful not to
scratch the paint.
4. Remove the door handle screws.
5. Pull door handle straight ahead to remove.
6. Rotate the lens 180 degrees.
7. Remove the transition plugs by sticking a small screw-
driver through the holes vacated by the door handle
plugs.
8. Rotate the lens 180 degrees.
9. Place the transition plugs into the holes vacated by the
door handle.
10. Rotate the lens 180 degrees.
11. Place the door handle through the lens and reattach
using the screws removed in step 5.
12. Insert the door handle hole plugs in the holes vacated
by the screws removed in step 5.
13. Remove the four screws that secure the door hinges to
the door.
14. Remove the 4 tie-in screws from the side of the door.
15. Using the 4 screws removed in step 4, reinstall the
hinges to the door.
16. Reinstall the 4 tie-in screws in the holes vacated by the
door hinge screws removed in step 4.
17. Using the 4 screws removed in step 2, reinstall the door
hinges in the screw holes on the right side of the door
opening.
18. Install the four hinge hole plugs removed in step 1 in the
open screw holes on the right side of the door opening.
9. Add
Transition
Plugs
11.
Replacement
of Handle
2. Remove
7. Removal
of
Transition
Plugs
Initial State
12. Add Door
Plugs
13. Remove
Hinges
8
4. Remove
Handle Screws
x2
screws
Steps 6, 8, 10
11. Add Handle
Screws
14. Remove Tie-in Screws
3. Remove
Plastic Plugs
x2
5. Pull Handle
Straight Ahead to
Remove From Door
After 180° Rotation
Step 15.
Add Hinges