Related Manuals for Advent TOCMR-OE100
Summary of Contents for Advent TOCMR-OE100
- Page 1 TOCMR-OE100 Install Manual...
-
Page 2: Installation Preparation
INSTALLATION PREPARATION Before starting installation: 1. Familiarize yourself with the installation instructions. 2. Inspect kit components (Refer to kit contents and hardware bag contents parts list located at the rear of this manual). 3. If you have any questions during this installation, please contact Audiovox Technical Support at 1-800-323-4815. - Page 3 7. Pull forward and side panels will come off. 8. Remove the screws from the center console pocket assembly. 9. Using the trim panel removal tool gently pry up the gear shift panel.
- Page 4 10. Unplug the heated seat switch if equipped. 11. Grasp the top half panel of the center console and lift upwards and remove. 12. Panel being lifted and removed.
- Page 5 13. Unplug the accessory port connector. 14. Remove the center console pocket and unplug. 15. Using the trim panel removal tool pry the AC vent assembly above the radio outwards.
- Page 6 16. Unplug the hazard switch. 17. Using a ten millimeter socket remove the mounting screws from the top of the radio. 18. Using a ten millimeter socket remove the mounting screws from the bottom of the radio.
- Page 7 19. Unplug all wiring harnesses connected to the radio. 20. Remove right side mounting bracket. 21. Remove left side mounting bracket.
- Page 8 22. Remove the climate control assembly from the radio. 23. Connect the climate control assembly to the new radio and install right side mounting bracket. 24. Install left side mounting bracket.
- Page 9 25. Remove the driver’s side door weather strip gasket along the A-pillar area. 26. Using the trim panel tool, pull the side airbag slightly away from the A-pillar. 27. Run the handsfree microphone plug between the side airbag and A-pillar.
- Page 10 28. Run the handsfree microphone plug between the dashboard and the A-pillar. Once the wire is positioned behind the dashboard, continue routing the wire to radio opening. 29. Mount the microphone and clip as shown the illustration. GPS Antenna Installation 30.
- Page 11 31. Mount the GPS antenna on the top of the AC vent. 32. GPS antenna is mounted. 33. Release the glove box door and lower it.
- Page 12 34. Place USB/ AV2 Interface Module in the glove box and route the wire harness to the back of the radio. 35. Attach all wire harnesses to the rear of the radio. Plug matching color connectors together. NOTE: Route the brown parking brake wire down to the center console emergency brake switch.
- Page 13 Power Speaker Speaker Connector Connector Parking Brake (-) Steering Wheel Controls Illumination Control Not Used Non JBL Connection Diagram...
- Page 14 Audio/Power Connector Parking Brake (-) Reverse Lights (+) Steering Wheel Controls Illumination Control JBL Module JBL Connection Diagram...
- Page 15 XM Module (Optional) USB/AV2 Interface Module Rear Camera iPod Connector GPS Antenna Accessory Cable (Optional) SIRIUS Satellite External Handsfree Control Microphone SIRIUS Module Optional. Cable Should Be Connected if SIRIUS Radio is to be Installed. Harness Layout Diagram...
- Page 16 Label Placement BEFORE AFTER BEFORE AFTER After the installation of the radio is complete, the factory AUX/USB port will no longer function. Place the black ahesive sticker to cover the lettering of the original port. Refer to illustration above. USB/AV2 Interface Module Label Label Two labels are provided for the USB/AV2 Interface module to...
- Page 17 Toyota Radio Parts List Item Part Number Title Unit 136-4853 Remote Control 1 with Battery (Front Zone) 130-2844 Polybag For Remote Control 136-4855 External Microphone 130-5217 Polybag for External Microphone 118-1221 GPS Antenna 138-1456 Velcro Strip,1" x 1.5"for GPS Antenna 130-5218 Polybag for Antenna 130-5219...