Speaker Connections - Boston Acoustics Horizon HS40 Owner's Manual

Use the lower screw hole
for vertical speaker position.
Rubber Bumper
Speaker tilts forward
I
when upper foot mounting
screw hole is used.
The Boston Horizon bookshelf models are designed to easily mount on the wall using the keyhole slot(s) on the back of the
speaker. When mounting the speakers to the wall, use the supplied rubber bumpers. You must remove the attached foot to
wall-mount your speakers. Remove the thumbscrew from the back of the foot. It is slotted for easy removal with a screwdriver
or a coin.
The keyhole mounting option is similar to hanging a picture frame on a wall. Install a screw into the sheetrock, making sure
to go into a stud, and hang the speaker onto the screw head. If a stud is not available a sheetrock anchor should be used to
support the weight of the speaker.
Keyhole Mount
Rubber Bumper
NOTE: You are responsible for the correct selection and use of mounting hardware (available through hardware stores) that
will ensure the proper and safe wall-mounting of the speakers.
Speaker Connections
After your speakers are properly placed, you are ready to wire your system. First, turn off all system power. Use the speaker
wire included with the system to make your connections. Please see the illustration below for guidance connecting the wires
to your speakers. For connection to your receiver, please refer to its owner's manual.
A typical 5.1 surround sound system
with an HPS subwoofer.
HS22S
HSSO
HS4S0
HSSO
5