325 LX Clean Sweep Assembly Drum Assembly 1. Push one of the drum axles onto either of the two gearcase output shafts. If necessary, rotate the drum axle until the clevis pin hole in the axle aligns with the matching hole in the gearcase output shaft.
Break-in and Operation If the machine is used in dusty conditions, the air filter should be saturated in air filter oil (see "Oiling the Air Filter" in the operators manual that came with the powerhead). Please check and clean the air filter often and replace the filter when necessary to prevent damage.
Operating Techniques Operate the Clean Sweep at or near full throttle with its sweeper fins resting on the work surface. IMPORTANT! It is both tiring and unnecessary to lift or hold the fins from the work surface during sweeping. When sweeping narrow areas such as sidewalks, the Clean Sweep can be used to throw material directly ahead of the operator.
Operating and Safety Tips Maintain a shallow angle to the work surface! A high angle of operation tends to propel the broom toward you, risking loss of control of the machine. The sweeper belts may rotate when the Clean Sweep is started! Always maintain a firm grip when starting the Clean...
Husqvarna Printed in U.S.A.