Moving By Hand - Husqvarna Z4822 Operator's Manual

Moving by Hand

WARNING!
No adjustments or maintenance
to be carried out unless:
- the engine stopped,
- the ignition key has removed,
- the parking brake is on.
When pushing or pulling the mower, be sure
to engage the IZT (Integraded Zeroturn
Transaxle) bypass linkages. The IZT bypass
linkages are located on the rear of the frame.
• Raise the deck into the highest cutting
position.
• Pull the IZT bypass linkages out and into
the slots and release so that it is held in
the bypass position.
• To reengage the IZT's to drive, reverse
the above procedure.
OPERATION
1. IZT Bypass linkages
Bypass linkages
1. Head outside of rear deck
2. IZT Bypass linkage in bypass position
Bypass position
8011-722
8011-722
33
English-