Toshiba 1550 Service Handbook page 18

1.3.A Installing the Carriage Drive Wire
(1) Set the wire so that its spherical terminal is
placed in the hole of the wire take-up pulley.
(2) Using the wire holder jig, wrap the wire on the
take-up pulley, 3-1/4 turns of the fixture-side
end and 5-1/4 turns of the other end.
(3) Wrap the wires on the front and rear sides, as shown and fasten them with screws.
[Front side]
Front side wire fixture
(Marking "F")
1
5 turns
4
closely fit
closely fit
Oct. 1995 © TOSHIBA CORP.
Hook (feed side)
Spherical terminal
1
3 turns
4
Spherical terminal
Wire take-up pulley
Hook (feed side)
Shaft
1 - 15
Wire take-
up pulley
Wire holder jig
[Rear side]
Rear side
wire
fixture
(Marking
"R")
1
1
5 turns
3 turns
4
4
closely fit closely fit
1550 ADJUSTMENT