Table of Contents
Advertisement
and decrease. Click the ones adjacent to the Range setting and you'll see
the image contrast increase and decrease. Here's a summary of how this
works:
Increasing the Back decreases the image brightness and vice-versa.
Increasing the Range decreases the image contrast and vice-versa.
Set the Back to 8,000 and the Range to 20,000 by typing in the fields
(without the comma) and then hit the Apply button to get us back to where
we started. When you manually enter values in the Back and Range you
must hit Apply to see the effect.
Let's learn a little more about the controls in the Contrast dialog. Click
the Invert checkbox and notice that the image now looks like a negative.
For images of faint objects, viewing the image as a negative by clicking
Invert can reveal faint structure.
Unclick Invert and then click Sharpen on and off several times while
looking at the fine detail in the image. With the Sharpen checked it's
almost as if the focus improves. That's the effect of Sharpen. It works
great on well-exposed images but tends to increase the noise in faint areas.
The last thing to try in the Contrast dialog is the Mag popup. It's set to
1:1 but selecting 2:1 or 4:1 zooms in on the image, enlarging the image
display. Selecting 1:2 or 1:4 zooms out on the image. Try the 1:2 and 2:1
settings. You may wonder if all these changes to the Contrast dialog are
destructive to the image data. They are not.
Changes to the settings in the Contrast dialog only affect the way the image
is displayed. They do not modify the actual pixel values.
In Summary
•
Clicking Auto is a good place to start with most images.
•
Back controls image brightness and Range controls contrast.
•
Clicking Invert can help reveal faint detail in images.
•
Clicking Smooth can reduce the noise in underexposed images.
•
Clicking Sharpen reveals additional detail in well-exposed images.
Establishing a Link
It's time to actually connect up to your camera and take some images. If
you haven't installed the drivers already go back to Section 2 and do so
now.
If you've taken a break from the tutorial and the camera isn't powered
up and attached to the computer do so now by connecting the USB cable
between the camera and the computer. At this point the green LED on the
back of the camera should be on.
SBIG ST-i Manual
15
Advertisement
Table of Contents
