Migrating Old Drivers From 32-Bit To Newer 64-Bit Systems - Santa Barbara Instrument Group ST-i Operating Manual

Note: If you previously installed SBIG 32-bit drivers using the old 32-
bit Driver Checker program and now want to install 64-bit drivers
over the old installation, follow the procedure outlined below:

Migrating Old Drivers from 32-bit to newer 64-bit Systems

This section describes how to migrate drivers from the old 32-bit only
DriverChecker to the new 32/64-Bit Compatible DriverChecker64.
1. Uninstall the old DriverChecker software.
a. Run the Add or Remove Programs Control Panel in the
b. Click on the SBIG Driver Checker entry and then click
2. Manually delete the old drivers files from the disk.
a. Delete the following files from the
3. Manually delete the old drivers files from the Device Manager.
a.
b. At the command prompt, type the following command ,
c.
d. In the View menu select the Show hidden devices
e.
f.
SBIG ST-i Manual
Start menu.
on the Change/Remove button.
C:\Windows\System32\Drivers directory:
sbigfldr.sys, sbiguldr.sys, sbiglldr.sys, sbigusbe.sys,
sbigusbi.sys
Some of these may not exist on your system but delete the
ones that do.
In the Start menu, point to All Programs, point to
Accessories, and then click Command Prompt.
and then press ENTER:
set devmgr_show_nonpresent_devices=1
Type the following command at the command prompt,
and then press ENTER:
start devmgmt.msc
command.
Expand the Universal Serial Bus controllers section by
click on the adjacent "+"
For each of the items listed below, right click on the item
then select Uninstall:
"SBIG USB Camera", "SBIG ST-402 Camera", "SBIG
USB Loader", "SBIG ST-L Loader", "SBIG ST-402
Loader"
9