Holland Apex BH421-SS5 Vinstruction Manual page 7

Bottom Assembly
Route electrode wire
through obround hole
1/4 - 20 Hex Bolts and
Lock Washer (both sides)
Cabinet Assembly
Step 3.
Refer to Figure 3. Select the following items:
1. grill bottom assembly
2. bucket bracket
3. electrode
❍
With the grill bottom assembly sitting upright on one end, locate the 1/4
inch diameter hole and slot close to the drain pipe hole. Insert the buck-
et hanger bracket in the slot as shown in Figure 3 and secure with 10-
24 x 1/2 Phillips head screw and lock washer. Tighten completely.
❍
Now insert electrode into hole and secure tightly with 8-32 screw and
lock washer. Next, loosen the two 1/4-20 hex bolts shown to prepare for
the next step. DO NOT REMOVE THEM!
Step 4.
Refer to Figure 4a and Figure 4b. Select the following items:
1. grill bottom assembly
2. cabinet assembly
3. tank heat shield
4. door assembly
❍
Figure 4a Place the grill bottom assembly onto the cabinet base
assembly. Secure the right side only at this time with 1/4-20 x 5/8 hex
head bolts and, lock washers as shown. Do not tighten at this time.
❍
Select the tank heat shield and slide it under the two bolts that you
loosened in the previous step. Be sure the obround cutout aligns with
the electrode and route the electrode wire through it. Lift the other end
of the tank heat shield up to the flange under the grill body as shown.
Now fasten both sides securely with 1/4-20 x 5/8 hex head bolts and
lock washers.
FIGURE 4a
1/4 - 20 Hex Bolt
1/4 Lock Washer
(both sides)
Secure right
side first
5. door pivot bracket
6. door knob
7. washer/spacer (2)
FIGURE 4b
Door Pivot Bracket
10 - 24 x 3/8
Phillips Screw
and Lock Washer
Knob
Washer / Spacers
Door Assembly
❍
Now bolt upper rear flange of cabinet sides to rear of grill bottom
assembly as shown. Use 1/4-20 x 5/8 hex head bolts and lock
washers. Tighten completely. Repeat for opposite side.
❍
Figure 4b Attach door knob to door panel using 10-24 x 3/8 Phillips
screw and lock washer as shown.
❍
Select the door pivot bracket, washer/spacers and door panel assem-
bly. Slide 1 washer/spacer onto the lower pivot pin of the door assem-
bly. Now insert lower pivot pin with the washer/spacer on it into the hole
in the top surface of the base assembly. Make sure the washer/spacer
do not fall off the pin. Place the door pivot bracket onto the upper door
pivot pin. Now bolt the door pivot bracket to the control panel bracket as
shown using 1/4-20 x 5/8 hex head bolt and lock washers.
❍
Fasten control panel to both cabinet sides using 1/4-20 x 5/8 hex head
bolts and lock washers. Tighten both sides securely.
Upper Door
pivot bracket 1/4 - 20 x 5/8
mounting Hex Bolt and Lock Washer
location
Cabinet Assembly
A-4