Holland Apex BH421-SS5 Vinstruction Manual page 6

Cabinet side, LEFT
Cabinet BACK
1/4 - 20 Hex Bolt
and Lock Washer
(typ 10 plcs)
Base Assembly
Heavy Duty Caster
Fasteners Guide
#8-32 x 1/2" Round Head Phillips
#10-24 x 1/2" Round Head Phillips
#10-24x1" Carriage Bolt
1/4 - 20 x 5/8" , 1/4 - 20 x 1" Hex Head Bolt
1/4 - 20 x 1" Round Head Phillips
Note: Use one lock washer per bolt, either under the hex nut or under
the bolt head if a hex nut is not used.
A-3
FIGURE 2b
Cabinet side, RIGHT
Cabinet side, RIGHT
8-32 x 3/8 Screw
Magnetic Catch
8-32 x 3/8 Hex Nut and Lock Washer
ASSEMBLY INSTRUCTIONS
#8-32 Lock Washer #8-32 Hex Nut
#10 Lock washer #10-24 Hex Nut
#10-24x1/2" Carriage Bolt
1/4" Lock washer
3/8"" Flat Washer
1/4-20 x 1/2" Thumb Screw
(For Tank Hold Down Bracket)
FIGURE 2a
10-24 Screw and
Lock Washer
(typ 4 plcs)
3/8" Flat Washer
Step 1.
❍
On a flat surface (table or carport floor), OPEN AND EMPTY BOTH
BOXES. REFER TO THE CONTENTS LIST TO BE SURE NO PARTS
ARE MISSING. Tighten all factory installed fasteners that may have
4 each T-Nut loosened during shipping.
Step 2.
Refer to Figure 2. Select the following parts for assembly:
1. cabinet side panels (2 ea)
2. base assembly
3. casters (4 ea)
❍
Attach magnetic catch to right cabinet side panel as shown in Figure
2a using 2 each 8-32 x 1/2 Phillips screws, nuts and lock washers.
1/4" Hex nut
❍
Place cabinet side panel onto base assembly as shown. Fasten with
1/4-20 x 5/8 bolts and lock washers as shown in Figure 2B. Do not fully
tighten at this time. Repeat for opposite side panel.
❍
Place Back Panel in between cabinet side panels as shown in
Figure 2B. Fasten with 10-24 x 3/8 screws and lock washers as shown.
Tighten completely. Now, go back and fully tighten cabinet side
panel bolts.
❍
Place one each 3/8" flat washer onto the caster stud. Now screw caster
into the base assembly corners. Tighten securely. Repeat for other 3
corners. NOTE: Locking casters go on the front. Lock the casters to
prevent cabinet from moving around during assembly.
FIGURE 3
Insert and fasten Bucket
Bracket into slot as shown
10-24 Phillips head screw
and lock washer
Loosen these 2 bolts.
DO NOT REMOVE
COMPLETELY
Electrode
8-32 Phillips head screw
and lock washer
4. back panel