Identifying External Components; Front Panel; Led Indicator; Reset - D-Link DGS-1248T Manual

IDENTIFYING EXTERNAL COMPONENTS

This chapter describes the front panel, rear panel, and LED indicators of the
Switch.

Front Panel

The figure below shows the front panels of the Switch.
10/100/1000 Base-T Twisted-Pair Ports w/ LED Indicators
┌─────────────────────────────┐
Figure 4. Front panel of 48-Port Gigabit Ethernet Switch

LED Indicator

Comprehensive LED indicators display the status of the Switch and the
network (see the LED Indicators chapter below).
1000BASE-T Twisted Pair Ports (Port 1~48)
The DGS-1248T is equipped with fourty-eight Gigabit twisted pair ports that
are auto negotiable 10/100/1000Mbps and also support auto MDI/MDIX
crossover detection. These ports can operate in half- and full-duplex modes.
SFP(Mini GBIC) Ports (Option Port 45~48)
The Switch is equipped with Four SFP(Mini GBIC) ports, supporting
optional 1000BASE-X SFP(Mini GBIC) transceivers.
Note: When the port is set to "Forced Mode", Auto MDI/MDIX will be
disabled.

Reset

The Reset button is used to reset all settings back to the factory defaults.
Note: Be sure that you record the settings of your device, or else all settings
will be erased when pressing the "Reset" button.
SFP(Mini GBIC) Ports
9
└──┘