Handset Battery Charging - VTech LS6195 User Manual

Getting started

Handset battery charging

Once you have installed the battery, the screen indicates the battery status (see the
table below).
• For best performance, keep the handset in the telephone base when not
in use.
• The battery is fully charged after 11 hours of continuous charging.
• If you place the handset in the telephone base without installing a battery,
the screen displays No battery.
Battery indicators
The screen is blank, or
displays Put in charger and
flashes.
The screen displays
Low battery and
The screen displays
HANDSET X.
When it is fully charged, you can expect the following performance:
Operation
While in handset use (talking*)
While in speakerphone mode (talking*)
While not in use (standby**)
* Operating times vary depending on your actual use and the age of the battery.
** Handset is not charging or in use.
After you install your telephone or power returns following a
power outage, the handset will prompt you to set the date and
time. For instructions, see Set date and time on page 13.
To skip setting the date and time, press OFF/CANCEL.
The battery has no or very
little charge. The handset
cannot be used.
The battery has enough
flashes. charge to be used for a
short time.
The battery is charged.
Battery status
Operating time
Up to seven hours
Up to three hours
Up to five days
4
Action
Charge without interruption
(about 30 minutes).
Charge without interruption
(about 30 minutes).
To keep the battery charged,
place it in the telephone
base when not in use.
Date: MM/DD/YY
ECO
ANS ON