Python 592 Owner's Manual page 73

Programming System Features
The System Features Learn Routine dictates how the unit operates. It is possible to
access and change most of the feature settings using the Control button.
1. Open a door.
2. Turn the ignition on, then off.
3. Select a Menu. Press and hold the Control button. The number of siren chirps
indicates the menu number. 1 chirp indicates menu 1, 2 chirps - menu 2 and
3 chirps for menu 3.
4. When the desired menu chirps are heard, release the Control button.
5. Select a Feature. Press and release the Control button the number of times
corresponding to the feature you wish to change. Then press and hold one
more time to select the features.
6. Program the Feature. While holding the Control button, you can program the
feature using the remote control.
For features with only two options;
~
=
option 1 while
~
=
option 2.
For features with more than two options;
~
selects the options in ascending order,
while
~
selects them in descending order.
Note: Pressing {:) button resets the feature to the factory default.
Once a feature is programmed:
• Other features can be programmed within the same menu
• Another menu can be selected
• The learn routine can be exited if programming is complete
Aux 3
Ti
med Output
Aux
3
Icon Type
1
to
90
sec.
1
to
16
min.
1/2/3/4
to
24
(Stortsl in increments
of 2
1/2/3/4
to
24
in
2
hour increments
Options: Not initiolized.
0
to
1000
in
50
millisecond
increments
To access another feature in the same menu:
1. Press and release the Control button the number of times necessary to advance
from the feature you just programmed to the next one you want to program.
2. Then press the Control button once more and hold it.
To select another menu:
1. Press and hold the Control button.
2. After 3 seconds, the unit advances to the next menu and the siren chirps, indi-
cating which menu has been accessed.
The learn routine exits if any of the following occurs:
• The open door is closed
• The ignition is turned On
• There is no activity for 30 seconds
• The Control button is pressed too many times
Bitwriter - Only Options
H
If programming with the Bitwriter®, the learn routine can be locked or un-
a
locked. If the learn routine has previously been locked, it must be unlocked
- with Bitwriter® - this cannot be done manually with the Control button.
The Bitwriter®
H
gives you access to a wider range of system options. These
features and the adjustments that may be programmed are described in the table
below. Default settings are in bold type.
Feature Opt. 2
Zone 4 Sensor Type
Siren Duration
Aux/Trunk Icon Type
Aux 1 Timed Output
Aux 1 Icon Type
Aux 2 Timed Output
Aux 2 Icon Type
© 2009 Directed Electronics. All rights Reserved.
Feature Menus
Default settings are in bold type. New features are bold with grey background.
Menu 1- Security