To Display The Setup Screen In Japanese - Omron WE70-AP Operation Manual

Chapter 3 Basic Setup
(1) <Radio Status> Button .........
3

■ To display the setup screen in Japanese.

1.
When the power of the wireless unit is turned ON again after turning OFF, the setup screen will be
displayed in English (Default Setting).
[For Reference]
• Some wireless LAN devices may use a name ESS ID for a wireless network name, which is same as SSID.
• To check access to an access point, specify LAN-end IP address (such as 192.168.0.1) of the access point based on a procedure
in 2-3. Connection Check, IP Address Setup (P.2-10).
A setup screen of the access point is displayed.
* In case of an access point, a password input is requested.
3-6
Radio wave intensity that an access point can receive is displayed
in the right of this button. If the client has different SSID and/or encryption
setup from the access point, "Communication Unavailable" is displayed.
Radio wave intensity is displayed in 4 levels as shown below.
Levels may differ depending on a communication type.
● Level:
Clicking <Radio status> allows monitoring of statuses of radio
communication such as channels and communication speed in the
[Wireless communication status].
Click
0-8 9-14 15-20
0-13 14-19 20-25
21 or higher (in case of 802.11a)
26 or higher (in case of 802.11b/g)