Kenmore 970-7050 Series Use & Care Manual page 8

Installation (Continued)
Leveling Freezer Drawer (if necessary)
To level the freezer drawer:
1. Check gasket seal around top, bottom, and sides of
freezer drawer.
2. If gasket is not sealed, open drawer and slightly loosen
four (4) drawer screws (two (2) on each side) to allow
drawer to rotate.
Remove Hex
Head Drawer
Screw
Do Not Remove
Other Screws
Remove Hex
Head Drawer
Screw
3. Close drawer and recheck the seal on the gasket (A).
Open the drawer grabbing by the sides in the center (B).
Be careful not to rotate the drawer.
Push Against
Freezer Drawer
A
4. Tighten four (4) drawer screws.
5. Recheck gasket seal.
Level Refrigerator & Adjust Doors (if
necessary)
Guidelines for final positioning of your refrigerator:
• All four corners of the cabinet must rest firmly on the floor.
• The sides should tilt ¼ inch (6 mm) from front to back
(to ensure that doors close and seal properly).
• Doors should align with each other and be level.
Most of these conditions can be met by raising or lowering
the adjustable front rollers.
Remove Hex
Head Drawer
Screw
Do Not Remove
Other Screws
Remove Hex
Head Drawer
Screw
Grab Drawer
At Center
From Both Sides
Then
Pull Drawer Out
B
To level the cabinet using the front rollers:
1. Slightly open freezer drawer. Lift the toe grille and
gently pull forward (see illustration).
2. You can raise or lower each door. Use a
wrench to turn the adjustment screws (1 per side).
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw counterclockwise.
3. Ensure both doors are bind-free with their seals
touching the cabinet on all four sides and that cabinet
is stable.
4. After unit is leveled, lower anti-tip leg until it contacts
the floor.
Door
Anti-tip
Leg
5. Install the toe grille by fitting into place.
8
/ inch socket
3
8
Door
Raise
Lower