Storage - Drive Medical Geo Owner's Manual

Attention
Before doing any maintenance, turn the power switch to OFF and remove the charger cords.
Suggestions
1. Do not splash water onto the power chair as this could cause the electronic system to malfunction.
2. Do not use caustic materials, solvents or aerosols as these may deform or damage the shrouds.
3. Do not use wax.

STORAGE

Make sure the power chair is stored as follows:
- With the charger unplugged
- With the power switch OFF
Suggestion
Always store the power chair in a location where it is out of direct sunlight, rain or dew. If storing for an
extended period, charge the battery to full power and then disconnect the battery terminal. For details
inquire to your dealer.
DISASSEMBLING THE GEO
The Geo can be disassembled in to four pieces, the seat (weight 18 lbs), the front section (weight 26.5
lbs),the rear section (35.5 lbs) and battery pack (weight 21 lbs), without any tools. Please follow the steps.
1. Switch off power of the power wheelchair.
2. Discount the connector of controller from the rear shroud.
3. Pull the Seat Rotate Lever while pulling up on the seat to remove.
4. Remove the battery pack...
5. Pull up the power wheelchair holding the seat post, while pulling the red handle behind the seat post...
6. Lift the front section up until the lower pegs are longer in contact with the curved locking brackets on
the rear section.
7 . I N S P E C T I O N A N D M A I N T E N A N C E
Knob lock
23