Table of Contents
Advertisement
♦ One Multi-language Quick Installation Guide
If any item is missing, or if you find any damage or mismatch,
promptly contact your dealer for assistance.
Installing the DP-100+
WARNING: Configuration problems may result if the DP-
100+ is powered up without first establishing
its
procedure to avoid complications at the
configuration stage.
1. Confirm proper operation of each of the printers to be
connected to the DP-100+. If you test your printers by
printing test files directly from a PC, then make each
printer's test connection to the PC through the same port
(serial or parallel) as the one you plan to use in
connecting to the DP-100+.
2. When you have confirmed proper operation of each
printer, switch its power off.
3. Confirm that your network is operating normally.
4. Connect the DP-100+ to the network cable, using either
the RJ-45 (10Base-T) or BNC (10Base2) connector on the
print server's side panel.
network
connection.
Follow
this
Unpacking and Installation
Advertisement
Table of Contents
Need help?
Do you have a question about the DP-100+ and is the answer not in the manual?
Questions and answers