Use Of Stacking Brackets - D-Link DP-100+ User Manual

◊ Steady or flashing green confirms that the DP-100+ is
powered on.
◊ The indicator blinks off briefly to indicate that the DP-
100+ is transmitting to the network.
♦ Link/Rx
◊ Steady or flashing green confirms that the DP-100+
has a good connection to the Ethernet network.
◊ The indicator blinks off briefly to indicate that the DP-
100+ is receiving from the network.
♦ LPT1, LPT2, COM
◊ These LED indicators light to show that the DP-100+
is transferring print data through the appropriate
parallel or serial port.
These three indicators are also used by the print server's
power-on self test (POST) to indicate any hardware
failures.

Use of Stacking Brackets

First, make sure you have one pair of stacking brackets for
each device.
Next, slide one bracket onto each end of the device as shown
in the diagram below. Be sure each bracket is positioned
correctly.
Introduction
DP-100+ Multiprotocol Ethernet Print Server User's Guide