Acer View 54e User Manual page 2

1. Turn the monitor on its
side or upside-down.
2. Insert the pegs on the
swivel base into the
cavities at the bottom of
the monitor. Push on
the swivel base until the
latch clicks shut.
Installing the Monitor
This monitor is equipped with an autosensing power supply for voltage
ranges 100-120VAC/200-240VAC, 60/50 Hz. Confirm the line voltage
designation on the rear panel of the monitor.
Follow these steps to install the monitor:
1. Before you connect the
cables, make sure that
the monitor and the
system unit
switches are Off.
2.
Plug one end of the 15-
pin signal cable to the
monitor and the other
end to the video signal
connector at the rear of
the system. Tighten the
two screws on the cable
2
power
User's Guide