Table of Contents
Advertisement
SERVICE AND ADJUSTMENTS
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
•
•
•
•
•
•
TO REMOVE MOWER (See Fig. 20)
Mower will be easier to remove from the right side of tractor.
•
Place attachment clutch switch in "DISENGAGED"
position.
•
Move attachment lift lever forward to lower mower to its
lowest position.
•
Roll belt off electric clutch pulley.
•
Disconnect anti-sway bar from chassis bracket by
removing retainer spring.
•
Disconnect suspension arms from rear deck brackets
by removing retainer springs.
•
Disconnect front links from deck by removing retainer
springs.
•
Raise lift lever to raise suspension arms. Slide mower
out from under tractor.
IMPORTANT:
IF AN ATTACHMENT OTHER THAN THE
MOWER IS TO BE MOUNTED TO THE TRACTOR, THE
R.H. AND L.H. SUSPENSION ARMS MUST BE REMOVED
FROM TRACTOR.
TO INSTALL MOWER (See Fig. 20)
•
Raise attachment lift lever to its highest position.
•
Slide mower under tractor with discharge guard to right
side of tractor.
•
Lower lift lever to its lowest position.
•
Install mower in reverse order of removal instructions.
Depress clutch/brake pedal fully and set parking brake.
Place motion control lever in neutral (N) position.
Place attachment clutch in "DISENGAGED" position.
Turn ignition key "OFF" and remove key.
Make sure the blades and all moving parts have completely stopped.
Disconnect spark plug wire from spark plug and place wire where it cannot come in
contact with plug.
SUSPENSION
ARMS
RETAINER
SPRING
ANTI-SWAY BAR
19
RETAINER
SPRINGS
(BOTH SIDES)
RETAINER
SPRINGS
(BOTH SIDES)
FIG. 20
ELECTRIC
CLUTCH
PULLEY
Hide quick links:
Advertisement
Table of Contents
