Coolant Level; Cleaning System - Mercedes-Benz CL Operator's Manual

Engine compartment
372

Coolant level

The engine coolant is a mixture of water and
anticorrosion/antifreeze.
When checking the coolant level, the vehicle
must be parked on level ground, and the
coolant temperature must be below 158‡
(70†).
G
Warning!
In order to avoid any potentially serious burns:
Use extreme caution when opening the
R
hood if there are any signs of steam or
coolant leaking from the cooling system, or
if the coolant temperature gauge indicates
that the coolant is overheated.
Do not remove the cap on the coolant
R
expansion tank if the coolant temperature
is above 158‡ (70†). Allow the engine to
cool down before removing the cap. The
coolant expansion tank contains hot fluid
and is under pressure.
Using a rag, slowly open the cap
R
approximately
to relieve excess pressure. If opened
immediately, scalding hot fluid and steam
will be blown out under pressure.
Do not spill antifreeze on hot engine parts.
R
Antifreeze contains ethylene glycol which
may burn if it comes into contact with hot
engine parts.
Example illustration: CL 550 4MATIC
1
/ turn counterclockwise
2
X
Using a rag, slowly open cap :
1
approximately /
2
to relieve excess pressure.
X
Continue turning cap : counterclockwise
and remove it.
The coolant level is correct if the level
for cold coolant: reaches marking bar
R
= in coolant expansion tank ;
for warm coolant: is approximately 0.6 in
R
(1.5 cm) higher
X
Add coolant as required.
X
Screw cap : back on and tighten it.
For more information on coolant, see the
"Technical data" section (
( Y page 494).
Washer system and headlamp

cleaning system

G
Warning!
Washer solvent/antifreeze is highly
flammable. Do not spill washer solvent/
antifreeze on hot engine parts, because it may
ignite and burn. You could be seriously
burned.
! Always use washer solvent/antifreeze
where temperatures may fall below
freezing point. Failure to do so could result
in damage to the washer system/fluid
reservoir.
! Only use washer fluid which is suitable for
plastic lenses. Improper washer fluid can
damage the plastic lenses of the
headlamps.
! Do not use distilled or deionized water in
the washer fluid reservoir. Otherwise, the
washer fluid level sensor could be
damaged.
Fluid for the washer system and the headlamp
cleaning system is supplied from the washer
fluid reservoir.
turn counterclockwise
Y page 491) and