Installing And Removing An Accessible 3; Installing An Accessible Drive - Fujitsu ESPRIMO P4 Series Operating Manual

Installing and removing an accessible 3

Installing an accessible drive

► Open the casing (see
Diskettedrive, Diskettedrive,
► Remove the drive (see
► Remove the front panel from the casing.
► From the inside, press the plastic drive cover out of the front panel.
► Break out the pre-stamped metal cover on the drive bay opening with a screwdriver (1).
► Secure the front panel on the casing again.
► Slide the drive into the casing (1). Make sure that the screw holes are aligned.
► Fasten the drive into place with the screws (2).
► Plug the data and the power supply connectors into the drive. Make sure the polarity is correct.
► Close the casing (see
Fujitsu Technology Solutions
"Opening the casing", Page
"Removing an accessible drive", Page
1
"Closing the casing", Page
/
1
31).
33).
2
2
32).
System expansions
inch drive
2
1
35