Installing An Accessible Drive - Fujitsu ESPRIMO P4 Series Operating Manual

System expansions

Installing an accessible drive

► Open the casing (see
Drive, Accessible drive,
► If a slide-in module is fitted, remove this first. To do this, proceed in the same way as
when removing a drive (see
Do not dispose of the empty slide-in module. For cooling, protection against
fire, and in order to comply with EMC regulations, you must refit the empty
slide-in module if you remove the drive again later.
► Take the new drive out of its packaging.
► Make the desired settings on the new drive (if necessary, to the settings of
drives already installed as well (Master/Slave)).
► Slide the drive into the casing (1). Make sure that the screw holes are aligned.
► Fasten the drive in place with the screws (2).
► Plug the data and the power supply connectors into the drive. Make sure the polarity is correct.
► Close the casing (see
It may be necessary to modify the entry for the drive in the BIOS Setup.
34
"Opening the casing", Page
"Removing an accessible drive", Page
"Closing the casing", Page
31).
33).
2
2
32).
Fujitsu Technology Solutions
1