Table of Contents
Advertisement
Sequence of Operation
Heating Operation
When using only a room temperature sensor, the thermostat operates the heating
system to maintain the Set Room Heat temperature.
When using only a floor temperature sensor, the thermostat operates the heating
system to maintain the Set Floor Heat temperature. In this case, the thermostat
does not try to control the air temperature. This is ideal for bathrooms and some
kitchen applications where the customer wants their feet to feel warm on the floor.
This is also ideal for garages so that the heating system is not affected by the
opening of the garage door in cold outdoor weather.
When using both a room temperature sensor and a floor temperature sensor, the
thermostat always maintains the Floor Minimum temperature, even when the air
temperature is satisfied. When the air temperature is below the Set Room Heat
temperature, the thermostat operates the heating system to maintain the Set Room
Heat temperature. The floor is never heated above the Floor Maximum setting in
order to protect the floor covering.
The H1 symbol is shown on the display when the thermostat is heating. The heat
can cycle on and off within +/- 1°C of the Set Room Heat temperature.
Freeze Protection
The thermostat operates the heat whenever the room or floor temperature falls
below 4.5°C.
-- -- -- ---- - - - - - ---- - - - - - -- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- --- - - - - -- - - ---- - - -- --- -- - - - - - - - - - - -- - - - -- - -- -- -- - -- - - - -- -
Exercising
When connected to a tekmarNet
relay for 10 seconds every 3 days. Exercising helps prevent zone valves or zone
pumps from failing due to precipitate buildup. During exercising, the thermostat
shows "TEST" on the display.
- - -- -- -- - --- - - -- - - - - - -- - -- - - - - - - - - - -- - -- -- - -- -- - - -- - - - -- - -- -
- - -- --- --- - - - - - ---- - - - - - --- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Flushing
The flushing feature is for open-loop systems that use a domestic hot water tank
as a heat source. Flushing ensures that fresh potable water is circulated through
the system once each day. If the thermostat is connected to a tekmarNet
control with the Flushing feature turned on, the thermostat display will display the
"FLUSH" icon for the duration of the flushing operation.
Hydronic System Supply Pump
When connected to a tekmarNet
setting affects how the primary pump or mix pump on the reset control operates.
When connected to the boiler bus, the primary pump is affected. When connected
to the mix bus, the mix system pump is affected.
If the thermostat operates a motorized zone valve or a zone pump, the Supply
Pump setting should be set to On.
--- - - ---- - - - - - ---- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
-- - - -- - - ---- - - - - - - - - - - - - - - - - - - - - - - - - - - -- -- - -- -- - -- - -
®
reset control, the thermostat exercises the heat
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -- - --
®
reset control, the thermostat's Supply Pump
15 of 24
Section A
© 2011
D 538e - 02/11
®
reset
Advertisement
Table of Contents
