Assembling The Vacuum Cleaner; Operating Handle; Dust Cup - Sharp EC-S2142 Operation Manual

ASSEMBLING THE VACUUM CLEANER

Pages within a frame show the ones where major points are explained.
Page
Name of each section and how to assemble

Operating handle

Hand control switch
Press to start, change mode and
turn off the operation.
Attach/ejector button
Remove the metal telescopic tube
while pressing the button.
Dusting brush
Joint pipe
Crevice nozzle
Metal telescopic tube
Extension/contraction button
Adjust the length while
sliding the button.
Fitting the brush to the metal
telescopic tube.
Suction head
(Floor head)
Accessories
Hose (1 piece)
2
EC-S2142,S2141.indd 2
Page 4
Page 4
Hook (rear side)
Metal telescopic tube (1 piece)
Floor head
(1 piece)
Air Turbine head
(1 piece)
(EC-S2142 only)
Joint pipe
(1 piece)
The hose can turn 360
degrees to prevent
excessive distortion.
Attach/ejector button
Remove the hose while
pressing the button.
Dusting brush (1 piece)
(Initially installed in
the operating handle)
Crevice nozzle (1 piece)
Alarm lamp /Dust disposal-
time indication
Exhaust outlet
The exhaust outlet incorporates
a n a l l e r g y d e f e n s e f i l t e r
and the product main body
incorporates an exhaust-air
ultra high efficiency air filter.
(Maintenance is unnecessary.
They are not detachable.)
care is needed. They are not

Dust cup

Page 7
11
Rotate the cup handle to open
the bottom lid.
Multi head (1 piece)
(EC-S2142 only)
Cleaning brush (1 piece)
(Installed in the product)
12.5.8 2:58:05 PM