Sharp EC-HX100M-S Operation Manual

EC-HX100M_P

TROUBLESHOOTING

Check the following FAQ section before contacting us for repairs or other questions.
Symptom
Cleaner trouble • Is the power plug disconnected from the socket?
•
during operation : If the cleaner body is overheated, the Filter care lamp (red)
will flicker quickly, and the cleaner will not start.
Leave the cleaner in a cool place for a while. Operation will be possible
Cleaner doesn't start
once the cleaner cools down.If the mesh filter or pleat filter is clogged,
wash with water.
• The dust cup assembly filter is dirty. Remove the dust cup assembly,
turn the filter knob, and empty the contents.
The Filter care lamp
(red) is ON • If the suction opening is blocked, this lamp may turn ON even if the filter
4
Page
is not dirty. In this case, press " OFF " and resume operation.
The lamp will turn OFF.
•
The motor is automatically controlled so that the hot air reaches
Suction force is weak a temperature range suitable for cleaning mattress. The motor power
or has changed will change automatically during operation, but this is not a problem.
• If the suction opening is removed from the bedding for more than
one minute, the power will automatically turn OFF. (Auto OFF)
Running sounds have • For safety purposes, operation will automatically stop approx.
changed or increased 30 minutes after starting.
• Is the mesh filter or pleat filter clogged? Remove the filters
and wash with water.
Operation stops • Is the dust cup full of dirt?
•
Is any large item such as tissues, etc. stuck inside the dust cup?
• Is the suction opening blocked with dirt? Remove the blocked dirt.
•
When using in a hot environment, such as during summer,
The Filter care lamp
the Filter care (red) may flicker quickly even if the filter is not clogged.
(red) is flickering quickly
In this case, leave the cleaner in a cool place for a while. Operation
Page 4
will be possible once the cleaner cools down.
If the cleaner stops during operation even after taking the above actions, contact your dealer or
the Customer Support Center.
Hot :
The cleaner body, power plug and power cord may reach a temperature of 40 to 60°C
during operation, but this is not a problem.
• Is the mesh filter or pleat filter clogged?
Cleaner body is hot
• The optical sensor will detect when the suction opening is lifted off
Beating rubber blade :
the bedding during cleaning, and the beating rubber blade will stop
for safety purposes.
• The optical sensor may not react when using the cleaner
on dark-colored (e.g., black or navy) bedding, so the beating rubber
Beating rubber blade
blade may stop. However, cleaning can be continued in this state.
doesn't rotate
• Are hairs or thread scraps wound around the rubber blade?
• When cleaning bedding that sits closely against the suction opening,
the fabric could be sucked up. The function to automatically stop
the beating rubber blade will activate and cause the rotation to stop.
Turn the power OFF once in this case.
The function will be deactivated and operation can be resumed.
Odors : • Is the dust cup full of dirt? (The dirt may smell depending on the type.)
• Was the mesh filter or pleat filter sufficiently dried after washing with water?
The exhausted
(Using the cleaner with wet filters can cause smells.)
air smells
SHARP CORPORATION
EC-HX100M_P.indd 1
Check here
Osaka, Japan
Printed in China
TINSEA160VBRZ 15J－ CN
Reference
MATTRESS VACUUM CLEANER
page
OPERATION MANUAL
---
MODEL
7-9
EC - HX100M - S
5,6
EC - HX100P - S
---
---
---
---
7-9
6,7
6,7 Plasmacluster is a registered trademark of
---
Sharp Corporation in Japan,
--- Philippines and elsewhere.
Device of a cluster of grapes is a trademark of
Sharp Corporation.
7-9
---
---
10,11
---
6,7
7-9
Thank you very much for buying SHARP.
Before using your SHARP vacuum cleaner,
please read this operation manual carefully
to obtain the best use from your vacuum cleaner.
①
SAVE THESE INSTRUCTIONS
WARNING
To reduce the risk of fire, electric shock or injury:
1 Electric shock could occur if used outdoors or on wet surfaces.
2 Do not leave unattended when plugged in, unplug from outlet
when not in use and before user-serving.
3 Close attention is necessary when used by or near children.
Do not allow to be used as a toy.
4 Use only for intended use as described cord or plug,
if it is not working properly, if it has been dropped,
damaged exposed to weather or dropped into water.
5 Never operate this vacuum cleaner if it has a damaged cord
or plug, if it is not working properly, if it has been dropped,
damaged, exposed to weather or dropped into water.
6 Do not pull or carry this vacuum cleaner by the power cord.
Do not use the power cord as a handle, close a door on the cord,
or pull the cord around sharp edges or corners.
Keep cord away from heated surfaces.
Do not run this vacuum cleaner over the cord.
7 Never disconnect the plug by pulling on the cord. To disconnect
from an outlet, grasp the plug, not the cord.
8 Never operate this vacuum cleaner with any air opening blocked.
Keep the air opening free of dust, lint, hair and any other similar
material. When the filter becomes dirty, rinse in water.
Filter should be completely dry before reusing.
9 Never drop or insert any object into any opening.
10 Never operate this vacuum cleaner without a dust cup.
11 Before removing the plug from the outlet, push switch to "OFF".
12 Never handle the plug, cord or vacuum cleaner with wet hands.
13 Do not place heavy objects on the vacuum cleaner.
14 Do not expose this vacuum cleaner to high temperatures
while operating or during storage.
15 Store this vacuum cleaner in a dry place.
16 Use the carrying handle of the body to carry this vacuum cleaner.
17 Children should be supervised to ensure that they do not play
with the appliance.
18 Operate vacuum cleaner only at the voltage specified
on rating label.
Stop use immediately
if following abnormality
or trouble occurs:
• The cleaner sometimes does not start even
when switch is turned ON.
• Power stops when the power plug or power cord
is moved.
• Operation sometimes stops.
• Abnormal noise is heard during operation.
• The cleaner body is deformed or abnormally hot.
• It smells like something is burning.
Press "OFF"immediately and disconnect
the power plug from the outlet.
Refer to "TROUBLESHOOTING", and contact
your dealer for repairs.
15/09/25 16:40