PURE M3700 User Manual page 52

Time Time
Configuration Source
NTP Server
Time Zone
Daylight
saving
protocol Signaling
Port
RTP
Base Port
System Restart
Restart Mode
Select the time server to synchronize
the time of this gateway
♦ Registrar: Get the time data from the
Registrar Server.
♦ NTP Server: Get the time data from
the NTP Server
Input the address if the system use
NTP server as time synchronization
source. The gateway will synchronize
with the NTP Server once a day. If the
NTP server inputted here is not
available or fail to response, the
gateway will retry it every 5 minutes.
The gateway has its own clock, so the
clock will keep going according to last
synchronization time. For NTP server
information, please refer to
http://www.ntp.org
Select local system time zone. Select
correct Time Zone.
ON: Enable daylight saving.
OFF: Disable daylight saving.
UDP port to transfer signal packets. It
can be setting in the range of 0 to
65535. (Must reboot system to apply
changes)(Only support VuTek device)
Base of UDP port to receive RTP
packets. It can be setting in the range of
0 to 65534.( Must be Even, after setting
this item, please reboot system to apply
changes)
None: Not to restart system.
Cold restart: Cold restart.
Warm restart: Warm restart.
50
Registrar
OFF
0
4000
None