Zanussi ZEE6940 User Manual page 16

• Installation and connection of the ap-
pliance to the power supply must only
be done by qualified personnel.
• Only use built-in appliances after you assem-
ble the appliance into correct built-in units
and work surfaces that obey the standards.
• Do not change the specifications or modify
this product. There is a risk of injury or dam-
age to the appliance.
• Fully obey the laws, ordinances, directives
and standards in force in the country where
you use the appliance (safety regulations, re-
cycling regulations, electrical safety rules
etc.).
• Keep the minimum distances to other appli-
ances and units.
• Install anti-shock protection, for example in-
stall the drawers only with a protective panel
directly below the appliance.
• If the fixing bracket is near to the terminal
block, always make sure the connection ca-
ble does not come in contact with the edge
of the bracket.
• Prevent damage of the cut surfaces of the
worktop against moisture with a correct seal-
ant!
• Seal the appliance to the worktop with no
space left with a correct sealant.
• Prevent damage of the bottom of the appli-
ance from steam and moisture, e.g. from a
dishwasher or oven.
• Do not install the appliance adjacent to
doors and below windows. Hot cookware
can be hit off the hob when you open doors
or windows.
• Disconnect the appliance from the elec-
trical supply, before you do mainte-
nance work or cleaning.
Warning! Risk of injury from electrical
current. Carefully obey the instructions for
electrical connections.
• The electrical mains terminal is live.
• Make the electrical mains terminal free of
voltage.
• Install correctly to give anti-shock protection.
16
• Loose and incorrect mains plug and socket
connections can make the terminal become
too hot.
• A qualified electrician must install the clamp-
ing connections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains connection cable and
replace the damaged mains cable with the
proper cable type. Speak to your local Serv-
ice Centre.
The appliance must have the electrical installa-
tion which lets you disconnect the appliance
from the mains at all poles with a contact open-
ing width of minimum 3 mm. You must have
correct isolation devices: line protecting cut-
outs, fuses (screw type fuses removed from the
holder), ground leakage trips and contactors.
The manufacturer is not responsible for
any injury to persons and pets or damage
to property caused by failure to obey
these requirements.
Electrical connection
• Ground the appliance according to safety
precautions.
• Make sure that the rated voltage and type of
power on the rating plate agree with the volt-
age and the power of the local power supply.
• The appliance is fitted with a five pole termi-
nal box whose cables are predisposed for
230 V monophase function.
1 2 3 4 5
In case of different voltage, carry out the
connection as shown in connection sche-
matic table on the lower protection.
• Any electrical component must be installed
or replaced by the Service Force Centre
technician or qualified service personnel.
• Always use a correctly installed shockproof
socket.
www.zanussi.com