Windshield Washer; Rear Window Wiper/Washer - Hummer H2 2010 Owner's Manual

Clear ice and snow from the wiper blades before using
them. If frozen to the windshield, carefully loosen or
thaw them. Damaged blades should be replaced.

Windshield Washer

{
WARNING:
In freezing weather, do not use your washer until
the windshield is warmed. Otherwise the washer
fluid can form ice on the windshield, blocking your
vision.
L
(Washer Fluid): Push the paddle marked with the
windshield washer symbol at the top of the multifunction
lever, to spray washer fluid on the windshield. The
wipers clear the window and then either stop or return
to the preset speed.

Rear Window Wiper/Washer

For vehicles with a rear window washer/wiper, the
button is located on the instrument panel to the left of
the instrument panel cluster.
{
WARNING:
In freezing weather, do not use your washer until
the windshield is warmed. Otherwise the washer
fluid can form ice on the windshield, blocking your
vision.
Z (Rear Wiper): Press to turn the rear wiper on and off.
The wiper speed cannot be changed.
Y (Wash): Press to spray washer fluid on the rear
window. Release the button when enough fluid has
been sprayed on the window. The rear wiper will run a
few more cycles after it is released. If the rear wiper
function was already on, prior to pressing the wash
button, it stays on until the wiper button is pressed
again.
(Delay): Press to turn on delayed wiping.
The rear window washer uses the same fluid that is in
the windshield washer reservoir. See Windshield
Washer Fluid on page 6 40.
4-7