Vehicle Immersion; Brake Lights - Polaris RANGER RZR Owner's Manual

Lights

Brake Lights

When the brake pedal is depressed, the brake light comes on. Check the
brake light before each ride.
1. Turn the ignition switch to the ON position.
2. Apply the brakes. The brake light should come on after about 10
mm (0.4 in.) of pedal travel. If the light doesn't come on, check the
bulb.

Vehicle Immersion

NOTICE: If your vehicle becomes immersed, major engine damage can result
if the machine is not thoroughly inspected. Take the vehicle to your
dealer before starting the engine.
If it's impossible to take your vehicle to a dealer before starting it, fol-
low the steps outlined below.
1. Move the vehicle to dry land.
2. Check the air box. If water is present, dry the air box and replace the
filter with a new filter. Thoroughly dry the air pre-filter. See page
93.
3. Remove the spark plugs.
4. Turn the engine over several times.
5. Dry the spark plugs and reinstall them, or install new plugs.
6. Attempt to start the engine. If necessary, repeat the drying proce-
dure.
7. Take the vehicle to your dealer for service as soon as possible,
whether you succeed in starting it or not.
8. If water has been ingested into the PVT follow the procedure on
page 92 for drying.
MAINTENANCE
107