Table of Contents
Advertisement
Seed Application
Preparing the Lawn
•
Cut the grass to approximately ½" (1-1.5 cm) lower
than you normally would.
•
Do not water before sowing.
•
Remove the layer of old grass cuttings (thatch).
•
Aerate the lawn with a core-type ground aerator.
•
Fertilize the lawn.
Seed Application Chart
Located on the seeder, the chart values are
approximate; quantities of seed depend on the speed
at which the machine is run. Faster running speeds
results in sparser sowing.
To set the seed application, loosen the wingnut and
turn the seeder dial to the desired sowing setting.
Retighten wingnut.
Pull back on the oPEN/CLoSE lever to apply seed.
Seed Application Recommendations
•
For best results, sow in two directions with a 45°
angle between.
•
Water generously immediately afterward and
continue watering moderately for 10–14 days to
keep the soil moist.
•
After germination, water sporadically to
encourage root growth.
Bagger Attachment and Removal
To attach bagger, place foot on safety door rear bolt
and push down until door is flat. Set the bagger onto
the door and up against the chute.
Secure bag clamp.
To remove door, unlatch bag clamp. Push down on
rear bolt and slide bagger away from the chute. The
safety door is spring loaded and will flip up to cover
the rear opening until the bag is reinstalled.
oPERATIoN
1.
Selection dial
2.
Wingnut
3.
oPEN/CLoSE lever
Set application per chart and turn on seeder
1.
Safety door
2.
Rear bolt
Attach bag to bagger frame
Secure bag latch
1
2
1
3
8060-021
2
8060-032
8060-023
19
Advertisement
Table of Contents
