Additional Features - Whirlpool Duet Steam Use And Care Manual

Electronic electric dryer
Hide thumbs Also See for Duet Steam:
Table of Contents

Advertisement

Available languages

Available languages

Manual Preset Cycle Settings
Manual Cycles
Load Type
TIMED DRY
Heavyweight items, bulky
items, bedspreads, work
clothes
QUICK DRY
Small loads
Air Only
Use Timed Dry/Air Only temperature setting for items that require
drying without heat such as rubber, plastic and heat-sensitive
fabrics. This chart shows examples of items that can be dried
using Air Only.
Type of Load
Foam rubber - pillows, padded bras, stuffed toys
Plastic - Shower curtains, tablecloths
Rubber-backed rugs
Olefin, polypropylene, sheer nylon
*Reset time to complete drying, if needed.
When using Air Only
Check that coverings are securely stitched.
Shake and fluff pillows by hand periodically during the cycle.
Dry item completely. Foam rubber pillows are slow to dry.
NOTE: Automatic Cycles are not available when using the Air
Only setting.
Steam Cycles
In these cycles, a small amount of water is sprayed into the dryer
drum after several minutes of tumbling with heat. The STEAM
status light will come on while the water is sprayed into the drum.
The dryer will continue to tumble at High heat for the duration of
the cycle. The Steam cycles include Quick Refresh and
Enhanced Touch Up. The heat setting and cycle time are not
adjustable for the Quick Refresh cycle, but can be adjusted for
the Enhanced Touch Up cycle.
NOTE: Results may vary depending on fabric. 100% cotton
garments with wrinkle-free finish may yield better results than
those without.
Use of a fabric softener sheet is not recommended with steam
cycles as it may cause temporary staining on the clothes.
Quick Refresh
This cycle is best for smoothing out wrinkles and reducing odors
from loads consisting of one to four dry items of wrinkle-free
cotton, cotton-polyester blend, common knits and synthetic
garments.
Enhanced Touch Up
This cycle uses water and heat to help smooth out wrinkles from
items such as clothes packed in a suitcase or wrinkled from
being left in the dryer too long.
16
Temperature
Default Time
(Minutes)
High
40
High
21
Time*
(Minutes)
20 - 30
20 - 30
40 - 50
10 - 20
Steam Preset Cycle Settings
Timed Cycles
Load Type
QUICK REFRESH
Helps to smooth out
wrinkles and reduce odors
from loads consisting of
one to four dry items.
ENHANCED TOUCH UP
Helps to smooth out
wrinkles in loads left in the
dryer for an extended
period.
*Temperature and time are selectable only for the Enhanced
Touch Up Cycle.
NOTE: The Enhanced Touch Up cycle has a minimum dry time of
15 minutes and a maximum dry time of 40 minutes. Only the
Medium and High temperature settings can be used for the
Enhanced Touch Up cycle.

Additional Features

Drum Light
Select Drum Light to turn on the light inside the dryer drum.
During a cycle, if Drum Light is selected, the drum light turns on
and will remain on until DRUM LIGHT is pressed again, the door
is open and closed, or the door is left open for 20 minutes.
When the dryer is not running, the drum light will turn on when
DRUM LIGHT is pressed or the dryer door is opened, and it will
remain on until the dryer door has been open for 20 minutes, the
dryer door is closed or DRUM LIGHT is pressed again.
Press DRUM LIGHT at any time to turn the drum light ON or OFF.
WRINKLE SHIELD™ Feature
When you are unable to remove a load of clothes from the dryer
as soon as it stops, wrinkles can form. The WRINKLE SHIELD™
feature periodically tumbles, rearranges and fluffs the load to help
keep wrinkles from forming.
Press the WRINKLE SHIELD™ feature to get up to
140 minutes of heat-free, periodic tumbling at the end of a
cycle.
Stop at any time by pressing the WRINKLE SHIELD™ feature
or opening the dryer door.
For the Casual Cycle, the WRINKLE SHIELD™ feature is
preset to "ON." The other cycles will retain the WRINKLE
SHIELD™ feature setting. (For example, if you select the
WRINKLE SHIELD™ feature in the Normal cycle, the
WRINKLE SHIELD™ feature will be on the next time you
select the Normal cycle.)
NOTE: If you do not select the WRINKLE SHIELD™ feature, the
dryer stops after the cool down period.
Default
Default Time
Temperature*
(Minutes)*
Medium
15
Medium
20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents