Service And Adjustments; Tire Care - Husqvarna CRT1350LS Owner's Manual

SERVICE AND ADJUSTMENTS

CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come
into contact with plug.
TILLER
TO ADJUST HANDLE HEIGHT (See Fig. 20)
Select handle height best suited for your tilling conditions.
Handle height will be different when tiller digs into soil.
• First loosen handle lock lever.
• Handle can be positioned at different settings between
"HIGH" and "LOW" positions.
• Retighten handle lock lever securely after adjusting.
HANDLE
(LOW POSITION)
handles_17

TIRE CARE

CAUTION: When mounting tires, un-
less beads are seated, over in fla tion
can cause an explosion.
• Maintain 20 pounds of tire pressure. If tire pressures
are not equal, tiller will pull to one side.
• Keep tires free of gasoline or oil which can damage
rubber.
TO REMOVE WHEEL (See Fig. 21)
• Place blocks under trans mis sion to keep tiller from
tipping.
• Remove hairpin clip and clevis pin from wheel.
• Remove wheel and tire.
• Repair tire and reassemble.
HANDLE
(HIGH POSITION)
HANDLE LOCK
LEVER
Fig. 20
TO REMOVE BELT GUARD (See Fig. 22)
• Remove hairpin clip and clevis pin from left wheel.
Pull wheel out from tiller about 1 inch.
• Remove cap nut and washer, and hex bolt and washer
from side of belt guard.
• Remove hex nut and washer from bottom of belt guard
(located behind wheel).
• Pull belt guard out and away from tiller.
• Replace belt guard by reversing above procedure.
BELT GUARD
HEX BOLT
AND WASHER
14
CLEVIS PIN
HAIRPIN CLIP
Fig. 21
CAP NUT AND
WASHER
HEX NUT
AND WASH-
ER
(LOCATED
BEHIND
TIRE)
HAIRPIN CLIP AND CLEVIS PIN
Fig. 22