Husqvarna 968999245/ CZ3815 Operator's Manual page 9

Husqvarna lawn mower user manual
Table of Contents

Advertisement

ASSEMBLY
Securely
tighten
bolt using a 7/16"
wrench or socket with ratchet.
Adjustments
may be required
to get uniform
positioning
of the control lever.
Refer to the
"Service
and Adjustment"
section
of this manual.
TO DRIVE THE MOWER
OFF OF THE
SKID (See Operation
section for location
and function
of controls)
NOTE: You may now roll or drive the mower off
of the skid.
Follow the appropriate
instruction
below to remove
the mower from the skid.
CONTROL
LEVER
CONTROL
ARM
FIGURE
2
TO ROLL THE MOWER
OFF OF THE SKID
(See Operation
section for location and
function
of controls)
Move to the rear of the mower,
and place
the EZT (E-Series
Zeroturn
Transaxle)
bypass
linkages
into the bypass
position
to disengage
the EZT's (See "TO
TRANSPORT"
in the OPERATION
section
of this manual).
Sitting on the mower,
press the deck lift
pedal in to the highest cutting
position.
Release
park brake lever, and exit
mower.
While pushing
on front or rear of mower,
roll the mower off of the skid.
Be sure all of the above assembly
steps
have
been completed.
Check
engine
oil level and fill fuel
tank with gasoline.
Place
the EZT(E-Series
Zeroturn
Transaxle)
bypass
linkages
into the
drive
position
(See "TRANSPORT"
in
the OPERATION
section
of this
manual).
Sit on the seat in the operating
position,
set the park brake lever to
the on or engaged
position.
Rotate
the control
levers
outward
into the neutral
slot.
Press forward
on the deck lift pedal
to raise the deck into the highest
cutting
position.
Place the throttle
control
into the
choke
position.
Insert ignition
key (can be found
in
the parts/owners
manual
bag) start
the engine,
allow
engine to warm,
move the throttle
control
to the idle
position.
Release
or disengage
the park brake.
Move the control
levers
into the
operate
position.
Slowly
move the control
levers
forward
and slowly
drive the mower
off of the skid.
Return
the control
levers
back to the
neutral
position.
Apply the park brake.
Turn the ignition
key to the "OFF"
position.
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents