Battery Replacement; Park Brake - Husqvarna 968999245/ CZ3815 Operator's Manual

SERVICE AND ADJUSTMENT
TO ATTACH JUMPER CABLES
Connect each end of the RED cable to
the POSITIVE (+) terminal on each
battery, taking care not to short against
chassis.
Connect one end of the BLACK cable to
the NEGATIVE (-)terminal of the fully
charged battery.
Connect the other end of the BLACK
cable to a good CHASSIS GROUND,
away from the fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER
BLACK cable first from chassis and then
from the fully charged battery.
RED cable last from both batteries.
Connect BLACK grounding cable to
negative (-) battery terminal with
remaining hex bolt and hex nut.
Tighten securely.
Close terminal access doors.
Lower seat.
REPLACING BATTERY (See Fig. 16)
FIGURE 16
TO ADJUST PARK BRAKE
In the disengaged position, the brake arms
should clear the brake sprocket slightly. If they do
not, remove some tension by turning adjuster nut
counter clockwise. Once clearance is estab-
lished in the disengaged position, engage the
brake by lifting the brake arm up and sliding to
your left into the slot.
Check to make sure teeth in brake arm are
engaged with teeth in brake sprocket.
Lift Seat and rotate forward.
Open terminal access doors.
Using two 1/2" wrenches disconnect
BLACK battery cable then RED battery
cable.
Using 7/16" wrench, remove terminal
guard.
Carefully remove the battery from the
mower.
Install new battery with terminals in the
same position as the old battery.
Reinstall terminal guard
First connect RED battery cable to
positive (+) battery terminal with hex bolt
and hex nut.
27
FIGURE 17