× Bookmark added
Page of 34
Download Table of Contents

Husqvarna 968999245/ CZ3815 Operator's Manual: Customer Responsibilities; Tires; Battery; Engine

Husqvarna lawn mower user manual.
Hide thumbs

Advertisement

SERVICE AND ADJUSTMENT
TO ADJUST
THE SEAT (See Fig. 1)
Move the control levers into the neutral
position and rotate to the outside of the
machine.
Lift up on the back of the seat and rotate
it forward.
Loosen the three prong knobs on the
bottom of the seat and move the seat to
the desired
position.
Tighten the three prong knobs and rotate
seat back to the operating
position.
TO ADJUST
CONTROL
LEVER
HEIGHT (See Fig. 2)
Sitting in the seat, in the operators
position, pull
both control
levers inward. If control levers are
too tall or too close to operators
legs, follow the
instructions
below for adjustment.
Using a 7/16" wrench or socket with
drive ratchet,
remove the four 1/4" bolts
retaining
the control levers.
Slide the control levers either up or down
to the desired
height, align holes and
reinstall
1/4" bolts.
Secure
bolt by tightening
with 7/16"
wrench
or socket with drive ratchet.
Remove
the spacer from the inside of
the caster
rim.
Repair tire
Reassemble
in the reverse
order of the
previous
steps.
REAR TIRES
IMPORTANT:
Block front tires to prevent
the
mower from rolling.
Park mower on a level surface
and apply
park brake.
Jack up the rear end of the mower on the
side of the damaged
tire.
Place jack stand under rear of mower
Remove
4 lug nuts to allow wheel
removal
Repair tire.
Reassemble
in reverse
order of previous
steps
NOTE:
To seal tire punctures
and prevent
flat
tires due to slow leaks, tire sealant
may be
purchased
from your local parts dealer.
Tire
sealer also prevents
tire dry rot and corrosion.
TO START AN ENGINE WITH A
WEAK
BATTERY
TO REMOVE
WHEELS
FOR
REPAIR
FRONTCASTERTIRES
Park mower on a level surface
and apply
park brake.
Jack up the front end of the mower.
Place jack stand under front of mower
Using a 3/4" wrench
and/or socket w/
drive ratchet, remove
hex nut and hex
bolt from the caster fork.
Remove
the tire from the fork.
If your battery is too weak to start the engine,
it
should
be recharged.
(See "BATTERY"
in the
Customer
Responsibilities
section
of this
manual).
If "jumper cables"
are used for emergency
starting,
follow this procedure:
IMPORTANT:
YOUR
MOWER
IS EQUIPPED
WITH A 12-VOLT
N EGATIVE
GROUNDED
SYSTEM.
THE OTHER VEHICLE
MUSTALSO
BE A 12-VOLT
NEGATIVE
GROUNDED
SYSTEM.
DO NOT USE YOUR MOWER
BATTERY
TO START
OTHER
VEHICLES.
26

Advertisement

   Related Manuals for Husqvarna 968999245/ CZ3815

Comments to this Manuals

Symbols: 0
Latest comments: