Download Print this page

Husqvarna 968999245/ CZ3815 Operator's Manual: Assembly; Service; Tools Required; Unpacking

Husqvarna lawn mower user manual.
Hide thumbs

Advertisement

ASSEMBLY
Your new mower has been assembled
at the factory with the exception
of those parts left un-
assembled
for shipping
purposes.
To ensure safe and proper operation
of your mower, all
parts and hardware
you assemble
must be tightened
securely.
Use the correct tools as
necessary
to insure
proper tightness.
TOOLS
REQUIRED
FOR ASSEMBLY
1.
7/16" wrench or 7/16" socket w/drive
ratchet
2.
Tire pressure gauge
3.
Nail bar or claw hammer
4.
Wire snips
When right or left hand is mentioned
in this
manual,
it means when you are in the operating
position (seated)
or left is trim side and right is
discharge side.
TO REMOVE
THE MOWER
FROM CRATE
UNPACK
CRATE
Place mower crate on fiat surface.
Using the nail bar or hammer, remove the
top of the crate first. Then remove the
sides of the crate and place these out of
the way.
Be careful of any exposed nails
or staples.
Remove the plastic bag that covers the
mower.
Using the wire snips, cut any plastic ties
that are holding the mower to the crate.
Remove the seat
and literature
bag from
shipping position at front of the mower
and place in a safe location, near by.
Raise the seat pan up to the vertical
position so that the bottom
can be easily
accessed.
Locate and finger-tighten
one of the three
prong knobs by inserting
it thru the seat
pan slot and into the corresponding
threaded
hole in the seat bottom.
Repeat for the other three holes.
Tighten the three prong knobs in the
approximate
position
desired
for the
seat.
Connect
the wiring
harness to the seat
switch.
Adjustments
may be required
to position the
seat in the desired
position.
Refer to the
"Service
and Adjustment"
section
of this
manual.
BEFORE
REMOVING
THE
MOWER
FROM
THE SKID
ATTACH SEAT (See Fig. 1)
Open parts bag(s) and locate the four (three
prong) knob seat fasteners
and four 1/4" hex
head bolts. Remove
both control
levers from
bag(s) and place in a safe location,
near by.
The seat position
should
be adjusted
forward
or
backward
so that the operator
can comfortably
reach the deck lift pedal and safely operate
the
mower.
See "Service
and Adjustment"
Section
of this manual.
Remove
protective
wrap from the seat.
FIGURE
1
ATTACH
CONTROL
LEVERS
(See
Fig. 2)
Locate 1/4" hex head bolts and control
levers.
Slide control lever over control arm with
handgrip
facing inward.
Slide control
lever to the approximate
height desired,
align hole in control
lever
with threaded
hole in control arm.
Start 1/4" bolt from the inside and finger-
tighten,
add second
bolt in second
hole
on same side of mower.
Repeat on opposite
side of mower for
second
control lever.
8

Advertisement

   Related Manuals for Husqvarna 968999245/ CZ3815

Comments to this Manuals

Symbols: 0
Latest comments: