Installing The Router On A Wall - HP MSR20-1X Series Installation Manual

To install the router to a workbench:
Place the router up-side down on the workbench, and attach the rubber feet to the four round holes
1.
in the chassis bottom.
Place the router top-side up on the workbench.
2.
Figure 21 Install the router to a workbench

Installing the router on a wall

To install the router to a wall:
Mark the locations of the two mounting holes on the wall.
1.
Drill two holes in the wall.
2.
Drill each hole at least 22 mm (0.87 in) deep, and make sure the two holes are on the same
horizontal line and 170 mm (6.69 in) apart.
Insert an anchor into each hole until it is all flush with the wall surface.
3.
Drive the screws into the anchors, keeping the screws at least 1.5 mm (0.06 in) outside the wall.
4.
Hang the router on the screws.
5.
16