Things To Keep In Mind - Sharp HV-50CXE Operation Manual

THINGS TO KEEP IN MIND

To correctly detect the temperature/humidity.
• Place the unit free from direct sunlight and warm air from air conditioners and heaters.
• Place the unit where the intake air temperature is between 0 ~ 35°C.
To reduce indoor humidity differences.
• Temperature and humidity will differ between areas near the floor and ceiling. It circulates through
indoor air.
Correct placement.
• Always place the unit on a stable, level surface.
• Maintain sufficient spacing as shown in the il-
lustration to prevent malfunctions, deterioration,
and damage as well as deformation and stain-
ing of walls and furniture from humidification.
About the current humidity display.
Current humidity display displays the humidity
measured with built-in temperature/humidity sen-
sors.
• The temperature will differ depending on the lo-
cation in the room. Select an appropriate loca-
tion for the placement of the unit.
• Immediately after the start of operation, the sen-
sors will be influenced by the internal tempera-
ture and humidity and requires about 5 minutes
for the current humidity display to stabilize.
Steam and mist are not visible.
• Since the unit uses the humidification method of
applying air to the humidification filter and dis-
charging humidified air (heat/evaporation ), steam
will not be visible as with steam fan type and ul-
trasonic type humidifiers.
Discharged air is not warm.
• Since the heat is taken when vaporizing water using the humidification filter even during heat/
evaporation operation, the discharged air will not be warm. Depending on the wideness of the
room, the air may even feel cold.
The amount of humidification
will vary depending on the tem-
perature and humidity.
• Since water is difficult to vaporize
under conditions such as high hu-
midity when there is rain or when
the temperature is low, the amount
of humidified air will be less.
(The tank water will decrease more
slowly.)
1.5m or more
0.15m or more
Level surface
(Use the humidity display only as a guide.)
Steam is not visible
from discharge port.
Amount of humidification and humidity
(Continuous operation)
700
Amount of
humidification
600
(mL/h)
500
400
300
250
0
0.25m or more
Humidity display lamp
Temperature/humidity
sensors
(Unit interior)
30 40 50
Humidity(%)
60
5