Table of Contents
Advertisement
CORRECT USAGE
3
Stopping operation
Press the Power ON/OFF button.
• All lamps will turn off the operation will stop.
To prevent rise in temperature within the unit, the fan will rotate
for about 1 minute after stopping operation. Remove the power
plug once the fan has stopped.
• Even during cluster ion operation, press the Power ON/OFF button
to stop operation.
• When the Power ON/OFF button is set to ON after turning off the
unit without removing the power plug, operation will start in the last
mode set before the unit was turned off by the memory feature.
However, the off timer will not be stored in the memory.
• Remove the power plug when leaving the house, during an earth-
quake or when not using the unit for an extensive period. (Even
with the Power ON/OFF button set to OFF, the unit will consume
about 0.5W of electricity.)
Turning off the cluster ion sign (blue) during cluster
ion operation.
(When thinking that cluster ion sign is too bright to night etc.)
(Cluster ions will be discharged even when the cluster ion sign is
turned off.)
Perform the following steps.
1
While the unit is not in operation, press and hold the Hu-
midity Select button and Cluster Ion button simulta-
neously for more than 1 second.
2 short setting beeps will be heard.
Setting is complete if the cluster ion sign (blue) does not
2
light when pressing the Power ON/OFF button and set-
ting the cluster ion operation to ON.
(To return the setting to the original state, repeat step 1 or
remove the power plug and reinsert to cancel the setting.)
When the tank is empty.
• Series of long beeps will be heard for about 10 seconds and the
water supply lamp will flash.
• The current humidity lamp and cluster ion sign will turn off and the
humidification operation will automatically stop.
(Humidification operation will restart automatically once the tank is
refilled.)
NOTE
• Water may drop when removing the tank. Drop the all water into the tray before removing.
• During operation, a clicking sound may be heard from the electrical components of the unit. However,
this is not a malfunction.
• Condensation may appear on the surface of the tank after filling when the room temperature is low or
immediately after turning off operation. However, this is not a malfunction.
• Set the tank into the unit slowly without dropping. Malfunction may occur as a result.
• Securely set the tray to the unit. Not setting the tray properly may cause the water supply lamp to flash,
preventing the unit from performing humidification.
12
Beep
Power ON/OFF button
Humidity select
button
Cluster ion button
2 short beeps
Press and hold simultaneously
for about 1 second.
Water supply
lamp
Long beeps
Flashing
Hide quick links:
Advertisement
Table of Contents
