Sunroof - Chevrolet Silverado 2007 Owner's Manual

The rails are notched at each end which allows
the tie-downs to be removed and placed on
another rail. To remove, pull the locator pin out
and slide the tie-down to the end of the rail
and pull back.
To remove or install cargo tie-downs at the front of
the bed, slide the corner cap towards the center of
the bed to expose the rail notches. To remove the
corner cap, pull either edge away from the rail.
To remove the system, loosen the toggle bolts
on each rail until they can be removed from
the bed of the truck. To replace the system,
place the toggle bolts and rails into their original
locations and tighten them to a torque setting
of 12.5 ft-lbs (17 Y ).
If the system is removed to install a bed liner,
make sure there is no bed liner material in
the installation points.
Notice: If you tie down cargo using the
horizontal slots on the top of the pickup box,
you may damage the box. Using the horizontal
slots on the top of the pickup box for tie-down
locations may cause damage to the pickup box
and would not be covered by your warranty.
Only use the tie-down loops if you do not have
the cargo management system.

Sunroof

If your vehicle has a power sliding sunroof,
the ignition needs to be turned to RUN, or the
Retained Accessory Power (RAP) must be
activated to open or close the sunroof. When RAP
is active, the sunroof will work for 10 minutes after
the ignition is turned off, or until the driver's door is
opened. See Retained Accessory Power (RAP) on
page 141 for more information.
205