Table of Contents
Advertisement
CONTROLS AND FEATURES
Repeat (only for DTV Clock On mode):
Select the desired On Timer operation (Once,
Every Day, Mon-Fri, Mon-Sat, Sat-Sun).
Input: Select a video input source (ATV, DTV
Ant, EXT 1, EXT 2, HDMI 1, HDMI 2, HDMI 3
or PC).
Channel: Set the channel that will be tuned
when the television turns on.
NOTE: When an external input is selected
in the Input fi eld, a channel cannot be
selected.
Volume: Set the volume that will be applied
when the television turns on.
Time until Power On (only for DTV Clock
Off mode): Set the amount of time from
now until the TV turns on using the number
buttons (maximum of 12 hours).
f
Press B or b to highlight Done and press
OK.
To cancel the On Timer
a
In the On Timer menu, select Enable On
Timer.
b
Press C or c to select Off .
c
Press C or c to highlight Done and press
OK.
Sleep Timer
The television can be set to turn itself Off after a
certain length of time.
a
Press MENU / C c to highlight Function
icon.
b
Press B / C c to highlight Sleep Timer icon
and press OK.
c
Use the number buttons to set the desired
time. For example, to switch the television
off in one and a half hours enter 01:30, or
press c / C to increase/decrease in steps of
10 minutes. (Maximum time setting is 12
hours)
d
Press EXIT to fi nish.
e
To cancel the Sleep Timer, enter all zeros for
the above setting.
Energy Saving Settings
Automatic Power Down
The TV will automatically turn itself off (standby) after
4 hours, if you do not operate the TV either from the
remote control or the TV control panel.
a
Press MENU / C c to highlight Setup icon.
b
Press B / C c to highlight Preference icon
and press OK.
c
Press B or b to select Energy Saving
Settings and press OK.
d
Press B or b to select Automatic Power
Down.
e
Press C or c to select On or Off .
NOTE:
•
This feature is set to
Home.
•
1 minute before switching to standby, a Warning
message will appear.
•
When the following features are set, the feature
that is set for the nearest time will function.
- Automatic Power Down
- Sleep Timer
- Auto shutdown after 1 hour of inactivity (after
power on by On Timer)
- No signal auto power off (after 15 minute of no
signal)
No Signal Power Down
The TV will automatically turn itself off after 15
minutes when no signal is detected. You can change
the setting to Off for the following purposes:
•
Low signal strength of analog channel (no signal
detection)
•
Only Audio L/R is connected to external input to
listen to music through the TV speakers.
a
In the Energy Saving Settings menu, press
B or b to select No Signal Power Down
and press OK.
b
Press B or b to select the item you want to
change and press C or c to select On or Off .
NOTE:
•
Default setting is all On.
•
A warning message will appear 1 minute before
turning off .
46
On when Location is set to
Hide quick links:
Advertisement
Table of Contents
