Check The Print Quality - Brother DCP-J132W Quick Start Manual

e
Gently put the paper into the paper tray print
side down and top edge first. Check that the
paper is flat in the tray.
IMPORTANT
Be careful that you do not push the paper in too
far; it may lift at the back of the tray and cause
paper feed problems.
f
Gently adjust the paper width guides to the
paper with both hands. Make sure that the
paper width guides touch the edges of the
paper.
g
Close the output paper tray cover.
h
Slowly push the paper tray completely into the
machine.
i
While holding the paper tray in place, pull out
the paper support a until it clicks, and then
unfold the paper support flap b.
6

Check the print quality

a
When the preparation process has finished, the
LCD shows this message
Set Paper and
q
Press Start
Press Colour Start.
b
Check the quality of the four colour blocks on
the sheet. (black/yellow/cyan/magenta)
c
If all lines are clear and visible, press a (Yes) to
finish the quality check and go to the next step.
If lines are missing, press b (No) and follow the
steps on the LCD.
2
1
OK
Poor
5