Table of Contents
Advertisement
Chapter 5 Programming the TK-850/SG2+UZ with
Table 5-1
30
WriteEZ1
WriteEZ1is the flash memory programming software which can erase and
program directly the flash memory of the microcontroller of the board via the USB
interface.
For details about the installation of the Flash Programmer WriteEZ1 software or
about the driver required for use, please refer to the section "6. V850 ZigBee
Gateway Development Platform, Installation and Operation"
To use WriteEZ1, please set the mode switch on the TK-850/SG2+UZ board as
follows. Then, please connect the board to your PC with a USB cable.
Flash programming mode settings for the TK-850/SG2+UZ
JP1
1-2-pin short (USB side)
Bit 1
ON
Bit 2
OFF
Bit 3
ON
Bit 4
ON
SW1
Bit 5
OFF
Bit 6
OFF
Bit 7
OFF
Bit 8
OFF
Please start WriteEZ1 by selecting [Programs] -> [NEC Electronics Tools] ->
[WriteEZ1] in your Windows [Start] menu.
User's Manual U19026EE3V0UM00
Advertisement
Table of Contents
