Back Panel - Honeywell Optimus 5100 User Manual

Rubber Feet
The bottom panel has four rubber feet to stabilize the unit on a flat surface. You can set the
base on a dry, stable surface, such as a desktop or workbench near an electrical outlet.

Back Panel

Serial Port
DC Power Jack
Connect the power cable to this power jack; see
page 9-3.
USB Port
The USB port is full-speed (v1.1). Using the USB cable, you can connect the base to a USB-
compliant device to facilitate USB communication to and from the terminal. USB
communication occurs through Microsoft ActiveSync (v.4.1 or higher). For more information
about ActiveSync setup, see
page 7-2.
Serial Port
The serial port supports serial communication between the terminal and another device. Note
that the connector is a DB9 Male connector, requiring a female connector on the serial cable.
The following four signals are supported:
• Transmitted Data
• Received Data
• Request to Send
• Clear to Send
Note: ActiveSync is not supported over the serial port.
9 - 2
USB Port
Connecting and Synchronizing the Terminal and Workstation
DC Power Jack
Powering the Optimus HomeBase Device on
on